WEEK 11 FYP2

WEEK 11

DATE: 07/10/2019-08/10/2019
SUPERVISOR: SIR SHAH RIZAILLI BIN MUKHTAR

👉 PREPARATION FOR EXHIBITION DAY

• I am experiencing difficulty the day before the presentation where the arduino nano board burn during the testing. There is no notification appear on the telegram when detecting the faulty alarm. Troubleshooting is made to identify the cause of the problem and also to check the connection of the wire with the component. I found out that maybe the arduino nano board is burn during soldering the jumper wire to the pin of arduino nano as my soldering technique is not very good. 
• Below is one of the example of how I did the soldering to the arduino nano board. The lead is too big and it may connected to the other pin.

Figure 1: Broken Arduino Nano

• The arduino nano board cannot be used anymore so I need to buy a new one. I went to the autobotic sdn bhd and luckily they still have the stock. I compile the coding into the new arduino board and placed it inside the box.
• The prototype is ready for presentation day.

Figure 2: Prototype

• After that, I am preparing myself on how to present and deliver the ideas of this project. 

DATE: 09/10/2019

👉 PRESENTATION DAY

The event start at 9 a.m. in Gemilang Hall. The students came early to the venue to prepare before the presentation. The accessor who accessed the students are Madam Siti Afifah and Mr Syukran from EASMED SDN BHD  and the presentation run smoothly. 

The picture below is taken after the done doing the presentation.

Figure 1: 

Picture with bunting and prototype

Figure 2: 

Picture with our supervisor, Mr Shah Rizailli and FYP2 coordinator, Dr Imran Sofi

\